Honda outboard service/repair manual – Seloc | 4-stroke | 4 stroke | Table of Contents PDF file | 2 hp – hp – 4 hp – 8 hp – 40 hp – 50 hp – 75 . Clymer Honda Outboard Marine service and repair manuals are written with model specific coverage for your Honda Outboard Marine. From basic service and. View and Download Honda Outboard Motor BFA owner’s manual online. Honda Power Equipment Outboard Motor Owner’s Manual. Outboard Motor.

Author: Vijin JoJojind
Country: Chile
Language: English (Spanish)
Genre: Politics
Published (Last): 16 July 2011
Pages: 355
PDF File Size: 12.19 Mb
ePub File Size: 19.11 Mb
ISBN: 791-5-76809-446-4
Downloads: 15010
Price: Free* [*Free Regsitration Required]
Uploader: Zuluran

If there was water in the engine crankcase, or if the used engine oil showed signs of water contamination, hlnda a outboarv engine oil change should be performed after running the engine for half an hour. To meet clean air standards, some areas of the United States and Canada use oxygenated fuels to help reduce emissions. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.

Honda Outboard Motor BF135A Owner’s Manual

outbosrd Please read them carefully. Honda power equipment outboard motor owner’s manual pages. If a fuse is blown, install a replacement fuse of the same specified rating. Check to be sure there are no fuel leaks before starting the engine. Do not try to remove the mud guard clip with f orce without raising the inner part of the mud guard clip.

Honda outboard repair manual – Table of Contents PDF file

Bad fuel; boat stored without treating or draining gasoline, or refueled with bad fuel. Page 75 Remove the three screws and separate the fuel strainer cup from the strainer body.

Shallow Water Operation LAUNCHING To raise the outboard motor out of the water while the engine is stopped and the boat outboaed moored, or for maximum clearance when beaching or launching, use the power tilt switch on the engine pan to tilt the Wipe up spills immediately.


If oil pressure becomes low, the indicator will go off, and the engine protection system will limit engine speed. Use a motor support bar to prevent the outboard motor from moving while trailering the boat. These gasolines are collectively referred to as oxygenated fuels.

After the first 20 hours or 1 month, then every hours or 6 months. It may also damage metal, rubber, and plastic parts of your fuel system. Replace fuel filters p. Page 88 Check fuel. Honda power equipment outboard motor owner’s manual 49 pages.

Remove the old fuse by removing two 5 mm screws. Page 96 If there is still no majual flowing from the cooling system indicator, or if the engine protection system remains activated after 30 seconds, return to the nearest boat landing, and have the outboard motor inspected by an authorized Honda marine dealer.

The propeller blades may have sharp edges, so wear heavy gloves to protect your hands. More Fuel Filter Inspection and Replacement. Refer to the maintenance schedule page Apply anticorrosion oil to pivot surf aces where grease cannot penetrate. Be sure to observe the following when servicing the spark plugs. Outboard motor bfaBfaBfa. Check that the fuel hose is undamaged and properly connected. Damage to the power tilt system may occur.

Wipe up any spills before starting the engine. Refuel carefully to avoid spilling fuel.

Honda Marine – 4-Stroke Outboard Motors, Parts, Accessories, Financing | Official Site

Improperly maintaining this outboard motor, or failure to correct a problem before operation, can cause a malfunction mahual which ownere could be seriously hurt or killed. The outboard motor is supplied with spare fuses in the fuse holder. Keep these items on the boat, so they will always be available if you need them. Stop the engine and keep heat, sparks, and flame away.

Related Articles  UTRYMNINGSLARM 2003 PDF

Stop the engine immediately if anyone falls overboard, and do not run the engine while the boat is near anyone in the water. Thoroughly clean the water separator cup. Power Tilt Switch The tilt lock lever is used to support the outboard motor in the fully-raised position.

To remove the mud guard clips, raise the inner part of each mud guard clip with a screwdriver, then pull out the clips. Tachometer optional Equipment The tachometer shows engine speed in revolutions per minute. For manual tilting, use a screwdriver to turn the valve counterclockwise 1 or 2 turns. Fuel filter or fuel tank clogged. Gasoline is highly flammable and explosive. Adjust the trim tab in small increments, and retest steering effort with the boat evenly loaded and running at cruising speed.

Reassemble the water separator body and the cup. The control lever automatically locks itself in the N neutral position. Possible Cause Out of fuel. Control lever not in neutral position. Remove the three screws and separate the fuel strainer cup from the strainer body. Fast idle lever raised side-mount type.

If the engine fails to start within 5 seconds, release the hlnda and wait at least 10 seconds before operating the starter again. Honda power equipment outboard motor owner’s manual 45 pages. You may purchase them from your Honda marine dealer. You can be burned or seriously injured when handling fuel.